Applicable for extremely cold situation of -50°C.
부담없이!
전기 없음
Almost maintenance-free
초고속 감지 및 소화
No parts need tobe replaced for up to 5 years
Simple & Easy to install
When the cylinder is triggered, the rising pressure in the pipeline opens the booster. All of the gas enters into the cylinder to provide additional injection power for the cylinder.
Ultra-low temperature fire extinguishing agent + fine spray = better suppression effect at lower temperature
The extinguishing agent rapidly cools the fire below ignition levels in seconds.
-50ºc up to 80ºc
전기 없음
초고속
낮은 유지보수
부담없이
Single-line system
(dex-ex)
완전 기계식
간편한 설치
스테인리스 강
매우 견고함
TiboRex Absolute는 고체 화재(화재 등급 A), 액체, 비극성 탄화수소(화재 등급 B) 및 식용 지방 및 오일의 매우 효과적인 소화를 위해 불소 화학 물질을 첨가하지 않은 즉시 사용 가능한 액체 특수 소화제입니다. 주요 성분이 식품 첨가물로도 사용되는 특수 제제는 전례 없는 환경 보호와 함께 탁월한 소화 성능을 보장합니다.
The fire suppression system is based on the principle of fine spray with rapid cooling technology. The patent nozzles spray the extinguishing agent DracoRex as very fine droplets. Through reflections and turbulence, the extinguishing agent also reaches adjacent areas, which enables the entire protected area to be protected. The service life of extinguishing agent containers (excluding fire extinguishing agents) is up to 10 years and easy to maintain. Once activated, they will need to be promptly returned to the factory for servicing or replacement to ensure that the fire extinguishing system can be operated again.
Protecfire uses thermos-pneumatic SPY fire detection elements to detect fire. These elements only activate the fire suppression system if a specified temperature is exceeded. Failure due to the failure of electrical components does not affect the normal start of the fire suppression system. Fire detection elements with different activate temperatures can be used because the protected area is not a thermally homogeneous area, but contains different temperature zones.
Protecfire RAPTOR detex 5062 fire suppression system is pressurized in the extinguishing container when it is in standby mode. For this reason, it is necessary to monitor the container pressure by observing the pressure gauge.
Yes. RAPTOR detex 5062 fire suppression system includes a linkage function – alarm and delayed shut down equipment or vehicle engine. When there is fire, the fire suppression system is activated, pressure switch works at the same time to generate signal to the alarm to indicate the fire suppression system is being activated. The control panel does not shut the equipment or vehicle engine down immediately, but delay for a period of approximately 20 seconds. This provides the operator with enough time to attend to other related equipment or guide the vehicle to a safe location.
Control Panel and 압력 스위치 must be installed for these additional optional operations.In addition, the devices that are to be switched off or on must be properly connected to the control panel. The system operates independently to other electrically operated components. Power for the pressure switch is supplied via the connection to the electrical system on the equipment.
RAPTOR detex 5062 fire suppression system consists of extinguishing agent container which is filled with extinguishing agent, pneumatic manual actuator, SPY fire detection element, nozzle, control line and extinguishing line and other optional parts. When a fire detection element is heated to its activation temperature, a mechanism opens the built-in argon propellant gas cartridge. This causes an increase in pressure in the control line. The pressure control valve in the extinguishing agent container will open to release the extinguishing agent through the line to the nozzles, completes fire suppression process. If the fire temperature does not reach its activation temperature, the fire suppression system can be activated by operating the pneumatic manual actuator. If the E-SPY electric manual actuator has been installed, the fire suppression system can be activated by remote electrical signal.
Korean 
English 
Chinese 
Japanese 
Russian